GRC Logo Call
01793 488899
grc.enterprise.ltd@gmail.com
Deck Loungers Raised Deck Baroque Rails Rope Deck
    HOME

TIMBER DECKING

BALUSTRADES


ROPE

DECK CARE PRODUCTS
Decking Restorer
Decking Cleaner
Decking Anti-slip
Decking Seal
Sprayable Deck Treatment
Rollable Deck Treatment
Decking Protector
Decking Oil
Decking Stain
Wood Preserver Clear
STAINLESS STEEL CABLE

FIXINGS

BROCHURES

HAMMOCKS

JUNGLE GYM

PRICE LISTS

SITE MAP

ABOUT US

 
Copyright ©
GRC Enterprise Ltd 2010
CUPRINOL WOOD PRESERVER CLEAR  
   

  Protects against rot and decay. For use before painting, staining or varnishing.

Wood Preserver Clear   
  Cuprinol Wood Preserver Clear (IP) is a colourless general-purpose preserver for interior or exterior use. It gives deep penetrating protection to sound wood against decay, mould and blue-staining fungi. 
 
  This low odour formula has been specially developed with low aromatic solvents to make it more pleasant and convenient to use.  
   


 
 




 
 
Pack Sizes
1 L, 2.5 L   and    5 L

 
 
How Much Is Needed
Small timbers, roof trusses, horticultural timbers: Apply 2 - 3 uniform coats by brush (1 litre per 6 - 7.5 sq. metre) or spray (1 litre per 4 - 6 sq. metre). Dip end grains for 3 minutes.
Outdoor timbers not in ground contact: Dip for at least 3 minutes if practical or brush or spray 2-3 uniform coats - Minimum 1 litre per 4 sq. metres (total). Rough sawn timber will absorb up to twice as much as planed wood.
 
 
Where To Use
Use on wood and joinery such as window frames, doors, etc. before painting, staining or varnishing. Use pre-treated timber if timber is in ground contact.

   
 
Preparing the surface

Ensure timber is dry and free from bark, dust/dirt and any surface coating including paint, varnish or polish.

   
 
How to apply
Treat all surfaces. Wherever possible dip timber in preserver. Otherwise apply uniformly, flooding faces, sides, ends and joints with at least two brush or spray coats. Apply the next coat after the previous coat has soaked in, but before it's dry. When spraying use a coarse (airless) sprayer and avoid atomisation (misting). The Cuprinol Shed & Fence Preserver Sprayer is ideal for this. Apply to any surfaces cut after treatment. Note: The application of this product may cause darkening of some timbers. If colour is critical try a test area to ensure acceptable appearance. After drying, glues, fillers, mastics and knotting can be used normally. Ensure wood is fully dry (allow 6-8 weeks), or use a vapour barrier such as heavy duty polythene (as used for damp proof membrane), before laying plastic floor coverings, rubber backed carpets or underlay, hanging vinyl wallpaper or using mastics. Do not spill on asphalt, bitumen, bitumen felt, tar, plaster, plastics, paint, etc.
   
 
Painting and finishing
Where required, finishes (oil or water based paints and varnishes, outdoor woodstains and polishes, etc.) can be applied normally to treated wood after the preserver has dried (normally 2-5 days for brush, spray or 3 minute dip, but may be longer in cold weather or poor ventilation).

   
 
Cleaning and storage
Clean equipment with white spirit. Remove as much preserver as possible from brushes before cleaning. For best results use Polycell Brush Cleaner. Do not use or store in extremes of temperature.

   
       
 

Always read the pack instructions carefully before use.