GRC Logo Call
01793 488899
grc.enterprise.ltd@gmail.com
Deck Loungers Raised Deck Baroque Rails Rope Deck
    HOME

TIMBER DECKING

BALUSTRADES


ROPE

DECK CARE PRODUCTS
Decking Restorer
Decking Cleaner
Decking Anti-slip
Decking Seal
Sprayable Deck Treatment
Rollable Deck Treatment
Decking Protector
Decking Oil
Decking Stain
Wood Preserver Clear
STAINLESS STEEL CABLE

FIXINGS

BROCHURES

HAMMOCKS

JUNGLE GYM

PRICE LISTS

SITE MAP

ABOUT US

 
Copyright ©
GRC Enterprise Ltd 2010
CUPRINOL ROLLABLE DECKING TREATMENT  
   

  The fast & easy way to protect & waterproof garden decking.

Rollable Deck Treatment   
  Cuprinol Rollable Decking Treatment's unique formulation, designed for roller application with the Cuprinol Decking Roller, saves time allowing most jobs to be completed in one day. Rollable Decking Treatment is quick-drying, low odour and safe with plants and pets when dry.
 
     
 
Colours 
Rustic Oak    Rich Teak   

Mountain Cedar    Natural Clear 
 



 
 




 
 
Pack Sizes
3 L
 
 
How Much Is Needed
A 3L pack is normally sufficient for:
Bare and previously stained wood:12m² with two coats
Absorbent wood, sawn wood and grooved decking will reduce coverage.
 
 
Where To Use
Cuprinol Rollable Decking Treatment is formulated for use on new or existing wooden decks. For maximum performance on decks Rollable Decking Treatment should be applied to all sides of wood prior to laying decking. A brush may be used instead of a roller for timber not yet assembled.
   
 
Preparing the surface

For timber in ground contact use pretreated timber. Timber specifically sold as decking is normally pre-treated with wood preserver to prevent decay. Surfaces should be free from algae and mould. Where these are present, brush decking to remove dirt and debris and then clean the surface with Cuprinol Decking Cleaner. Rinse well and allow to dry. Resinous or oily wood may affect performance.
New wood: If necessary wipe with white spirit to remove any natural oils/resins.
Weathered wood: Completely remove all grey wood by sanding back to clean sound wood, or by using Cuprinol Decking Restorer.
Painted or varnished wood: Sand off or chemically strip existing coatings then treat as bare wood.
Sound woodstained wood: Wash with Cuprinol Decking Cleaner to remove dirt and grease and allow to dry.

   
 
How to apply
Remove lid and stir well before use. For best results, cut in where necessary (e.g. between slats) by brush before rolling. Fully submerge roller, remove excess fluid by rolling on grid, then apply Cuprinol Rollable Decking Treatment to your timber, rolling in the direction of the slats. Do not allow the Rollable Decking Treatment to form pools in the grooves. This can be avoided by ensuring that the roller is not overloaded, and by not applying excessive pressure during application. As with all rollers, it takes a few minutes of use to reach optimum performace whilst the fluid is absorbed deep into the pile core. One coat is normally sufficient, although more may be applied for extra protection. Do not apply if rain is likely before treatment can dry, or if the temperature is below 5°C, or in conditions of high humidity or frost.
   
 
Drying time
Cuprinol Rollable Decking Treatment will be touch dry in 2-6 hours in good drying conditions. When applying subsequent coats allow to dry fully before recoating. Avoid heavy wear and tear for a few days after application. On previously repaired decking, touch up bare areas and allow to dry before finishing with further coats. Apply 1 to 2 coats depending on the degree of protection required.
   
 
Cleaning and storage
Reseal tub after use. Clean up any spills while still wet. Remove as much product as possible from roller before washing well with water. Do not use or store in extremes of temperature and protect from frost.
   
       
 

Always read the pack instructions carefully before use.