GRC Logo Call
01793 488899
grc.enterprise.ltd@gmail.com
Deck Loungers Raised Deck Baroque Rails Rope Deck
    HOME

TIMBER DECKING

BALUSTRADES


ROPE

DECK CARE PRODUCTS
Decking Restorer
Decking Cleaner
Decking Anti-slip
Decking Seal
Sprayable Deck Treatment
Rollable Deck Treatment
Decking Protector
Decking Oil
Decking Stain
Wood Preserver Clear
STAINLESS STEEL CABLE

FIXINGS

BROCHURES

HAMMOCKS

JUNGLE GYM

PRICE LISTS

SITE MAP

ABOUT US

 
Copyright ©
GRC Enterprise Ltd 2010
CUPRINOL DECKING PROTECTOR  
   

  A treatment that gives long lasting protection against weather & decay.

Decking Protector   
  Cuprinol Decking Protector (A) gives superior protection to all types of garden decking. It has a special triple action formula that protects garden decks in 3 ways.
 
  The wax enriched formula penetrates deep into the wood to increase water repellency and help prevent cracking and splitting. Secondly, biocides protect against mould, fungi and green algal growth. Finally, a preservative gives lasting protection against all types of rot and decay. The clear formulation provides protection against the effects of weather, while the natural woodshade colours provide both decoration and protection.
 
 
Colours 
Golden Teak    Rustic Oak    Clear     
 



 
 




 
 
Pack Sizes
5 L

 
 
How Much Is Needed
Brush or spray: One litre will treat 3-6 square metres. If dipping, dip for at least 3 minutes.
Note that weathered or rough sawn wood and grooved decking will reduce coverage.
 
 
Where To Use
Cuprinol Decking Protector (A) is suitable for use on all types of timber decking including boards and tiles. It protects pre-treated timber from the effects of the weather and preserves the cut ends. It also provides protection, decoration and preservation for untreated timber used for decking. Regular application will ensure continued protection. Decking Protector (A) is not normally intended to be overcoated with other decorative finishes, however if required, allow to weather before using a stain or similar finish. Test for colour acceptance first. Store and use at temperatures above 10°C. Treatment will take an average of 3 days to dry depending on conditions.

   
 
Preparing the surface

Most timber sold specifically for decking will be pre-treated with a preservative to prevent decay. In this case, no additional preservative treatment is required. However, if the timber is cut or drilled, Cuprinol Decking Protector (A) should be used on the newly exposed surfaces to maintain protection from decay before construction. All timber should be clean, dry and free from any previous surface coating. Remove any dirt, mould or algal growth using Cuprinol Decking Cleaner and allow to dry.

   
 
How to apply
Shake tin well before and frequently during use. This is important to achieve a uniform colour. Do not allow the Cuprinol Decking Protector (A) to form pools in the grooves. This can be avoided by ensuring that the brush is not overloaded and by not applying excessive pressure during application. Apply 2 generous coats by brush or spray to all surfaces. Apply the second coat after the first has soaked in but before fully dry. Make sure that end grain, cut ends and joints are well treated.
   
 
Drying time
Treatment will take an average of 3 days to dry depending on conditions.

   
 
Cleaning and storage
Remove as much preserver as possible from brushes before cleaning. For best results use Polycell Brush Cleaner. Do not use or store in extremes of temperature. Clean any spills while still wet. Reseal can after use.

   
 
The assurance of Cuprinol
For maximum protection the special Cuprinol formula has been developed to penetrate 10 x deeper than many other wood treatments.  
   
       
 

Always read the pack instructions carefully before use.