GRC Logo Call
01793 488899
Deck Loungers Raised Deck Baroque Rails Rope Deck




Decking Restorer
Decking Cleaner
Decking Anti-slip
Decking Seal
Sprayable Deck Treatment
Rollable Deck Treatment
Decking Protector
Decking Oil
Decking Stain
Wood Preserver Clear








Copyright ©
GRC Enterprise Ltd 2010

  A clear coating that gives an antislip finish and helps prevent the growth of green algae.

  Cuprinol Anti-Slip Decking Treatment is a clear, natural matt finish that helps make decking safer especially when wet by improving slip-resistance.

  It has a unique, double action formulation that works in two ways. Cuprinol Deck-Grip Microbead technology gives a non-abrasive, anti-slip finish, whilst powerful algicides help protect the film from the growth of green algae and mould. Cuprinol Anti-Slip Decking Treatment also provides a water repellent finish that seals and protects. It is ideal for use on decks that are partially shaded and in preparing decks for the winter months.
Pack Sizes
2.5 L
How Much Is Needed
A 2.5 litre pack is normally sufficient for: 30m² with one coat. It is important that this coverage rate is achieved in order to provide the necessary anti-slip properties, do not brush out too thinly. More than one coat may be necessary in some cases. Absorbent wood, sawn wood and grooved decking will reduce coverage.
Where To Use
Cuprinol Anti-Slip Decking Treatment is suitable for use on all types of new or used bare and stained timber decking. Certain penetrating finishes such as Cuprinol Decking Oil, Cuprinol Decking Seal and Cuprinol Decking Protector will need to be weathered prior to the use of Cuprinol Anti-Slip Decking Treatment. If in doubt try a test are a first for appearance and adhesion or contact Cuprinol.
How to apply
Stir well before and occasionally during use. Apply using a brush or roller. Apply at the recommended coverage rate but do not allow the Treatment to pool in grooves. Brush or roll out any accumulations on the surface of the decks. Cuprinol Anti-Slip Decking Treatment is white on application but dries to a clear matt finish. Do not apply if rain is likely before the treatment can dry, if the temperature is below 5°C or in conditions of high humidity or frost.
Drying time
Touch dry in 2-6 hours in good drying conditions. Recoat when previous coat is fully dry. As with many waterbased coatings, some whitening of Cuprinol Anti-Slip Decking Treatment may occur if it gets wet soon after application. This whitening will disappear when the surface dries out.
Cleaning and storage
Remove as much product as possible from application equipment before washing out with water. Reseal container after use. Wash off any splashes with water while still wet. Do not use or store in extremes of temperature and protect from frost.
WARNING, this is not a non-slip product. The anti-slip* properties will be reduced if decks become dirty, dusty or leaves and decaying vegetation are allowed to accumulate. Clean the treated decking periodically using Cuprinol Decking Cleaner to avoid any reduction in performance and depending on wear, re-treat with Cuprinol Anti-Slip Decking Treatment to maintain the anti-slip performance.
Other Information
* When regularly maintained, Cuprinol Anti-Slip Decking Treatment achieves 'low potential for slip' category when tested to the UK Slip Resistance Group guidelines and BS 7976.

Always read the pack instructions carefully before use.